Cisco C9130AXI-S Cisco Catalyst 9130AX Series Access Point, internal antennas; Wi-Fi 6; 4×4:4 MIMO, S Domain
Điểm truy cập Cisco Catalyst 9130AX là thế hệ tiếp theo của điểm truy cập doanh nghiệp. Họ kiên cường, đảm bảo và thông minh. C9130AXI-S là Điểm truy cập Dòng Cisco Catalyst 9130AX, ăng-ten bên trong; Wi-Fi 6; Miền 4×4: 4 MIMO, S.
Mở rộng mạng dựa trên mục đích của Cisco và hoàn hảo cho các mạng ở mọi quy mô, Cisco Catalyst 9130AX Series đáp ứng nhu cầu ngày càng tăng của IoT trong khi hỗ trợ đầy đủ các cải tiến mới nhất và công nghệ mới. Dòng 9130AX cũng dẫn đầu về hiệu suất, bảo mật và phân tích.
Điểm truy cập Cisco Catalyst 9130AX Series, được ghép nối với Kiến trúc mạng kỹ thuật số của Cisco (Cisco DNA), là sản phẩm cấp doanh nghiệp sẽ giải quyết cả nhu cầu hiện tại và tương lai của bạn. Đây là bước đầu tiên trong quá trình cập nhật mạng của bạn để tận dụng tốt hơn tất cả các tính năng và lợi ích mà Wi-Fi 6 cung cấp.
C9130AXI-S | Thông số kỹ thuật |
Software | Catalyst 9130AXI |
Cisco Unified Wireless Network Software Release 8.10.x or later | |
Cisco IOS ® XE Software Release 16.12.1 with AP Device Pack, or later | |
Supported wireless LAN controllers | Cisco Catalyst 9800 Series Wireless Controllers |
Cisco 3504, 5520, and 8540 Wireless Controllers and Cisco Virtual Wireless Controller | |
802.11n version 2.0 (and related) capabilities | 4×4 MIMO with four spatial streams |
Maximal Ratio Combining (MRC) | |
802.11n and 802.11a/g | |
20- and 40-MHz channels | |
PHY data rates up to 1.5 Gbps (40 MHz with 5 GHz and 20 MHz with 2.4 GHz) | |
Packet aggregation: Aggregate MAC Protocol Data Unit (A-MPDU) (transmit and receive), Aggregate MAC Service Data Unit (A-MSDU) (transmit and receive) | |
802.11 Dynamic Frequency Selection (DFS) | |
Cyclic Shift Diversity (CSD) support | |
802.11ac | 8×8 downlink MU-MIMO with eight spatial streams |
MRC | |
802.11ac beamforming | |
20-, 40-, 80-, and 160-MHz channels | |
PHY data rates up to 6.9 Gbps (160 MHz with 5 GHz) | |
Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) | |
802.11 DFS | |
CSD support | |
WPA3 support | |
802.11ax | 8×8 uplink/downlink MU-MIMO with eight spatial streams |
Uplink/downlink OFDMA | |
TWT | |
BSS coloring | |
MRC | |
802.11ax beamforming | |
20-, 40-, 80-, and 160-MHz channels | |
PHY data rates up to 10 Gbps (160 MHz with 5 GHz and 20 MHz with 2.4 GHz) | |
Packet aggregation: A-MPDU (transmit and receive), A-MSDU (transmit and receive) | |
802.11 DFS | |
CSD support | |
WPA3 support | |
Integrated antenna | 2.4 GHz: Peak gain 4 dBi, internal antenna, omnidirectional in azimuth |
5 GHz: Peak gain 6 dBi, internal antenna, omnidirectional in azimuth | |
External antenna with Smart antenna connector | The Cisco Catalyst 9130AXE Access Point is certified for use with antenna gains up to 13 dBi (2.4 GHz and 5 GHz) |
Cisco offers the industry’s broadest selection of antennas, delivering optimal coverage for a variety of deployment scenarios | |
Supports Self-Identifiable Antennas (SIA) on the Smart antenna connector | |
Smart antenna connector is a compact multi-RF connector with 8-DART interface | |
Requires the AIR-CAB002-D8-R= 2-fppt smart antenna connector when used with antennas with a RP-TNC connector | |
Requires the AIR-CAB003-D8-N= 3 ft smart antenna connector when used with AIR-ANT2513P4M-N= antenna | |
Interfaces | 1x 100, 1000, 2500, 5000 Multigigabit Ethernet (RJ-45) – IEEE 802.3bz |
Management console port (RJ-45) | |
USB 2.0 at 4.5W (enabled via future software) | |
Indicators | Status LED indicates boot loader status, association status, operating status, boot loader warnings, and boot loader errors |
Dimensions (W x L x H) | Access point (without mounting brackets): – C9130AXI: 8.9 x 8.9 x 1.88 in. (22.6 x 22.6 x 4.8 cm) |
Environmental | Cisco Catalyst 9130AXI |
Nonoperating (storage) temperature: -22° to 158°F (-30° to 70°C) | |
Nonoperating (storage) altitude test: 25˚C, 15,000 ft (4600 m) | |
Operating temperature: 32° to 122°F (0° to 50°C) | |
Operating humidity: 10% to 90% (noncondensing) | |
Operating altitude test: 40˚C, 9843 ft (3000 m) | |
Note: When the ambient operating temperature exceeds 40°C, the access point will shift from 8×8 to 4×4 on the 5 GHz radio, uplink Ethernet will downgrade to 1 Gigabit Ethernet; however, the USB interface will remain enabled. | |
System memory | 2048 MB DRAM |
1024 MB flash | |
Available transmit power settings | 2.4 GHz |
23 dBm (200 mW) | |
20 dBm (100 mW) | |
17 dBm (50 mW) | |
14 dBm (25 mW) | |
11 dBm (12.5 mW) | |
8 dBm (6.25 mW) | |
5 dBm (3.13 mW) | |
2 dBm (1.56 mW) | |
-1 dBm (0.79 mW) | |
-4 dBm(0.39 mW) | |
5 GHz | |
26 dBm (400 mW) | |
23 dBm (200 mW) | |
20 dBm (100 mW) | |
17 dBm (50 mW) | |
14 dBm (25 mW) | |
11 dBm (12.5 mW) | |
8 dBm (6.25 mW) | |
5 dBm (3.13 mW) | |
2 dBm (1.56 mW) | |
-1 dBm (0.79 mW) | |
Maximum number of nonoverlapping channels | 2.4 GHz |
802.11b/g: | |
– 20 MHz: 3 | |
802.11n: | |
– 20 MHz: 3 | |
802.11ax: | |
– 20 MHz: 3 | |
5 GHz | |
802.11a: | |
– 20 MHz: 26 FCC, 16 EU | |
802.11n: | |
– 20 MHz: 26 FCC, 16 EU | |
– 40 MHz: 12 FCC, 7 EU | |
802.11ac/ax: | |
– 20 MHz: 26 FCC, 16 EU | |
– 40 MHz: 12 FCC, 7 EU | |
– 80 MHz: 5 FCC, 3 EU | |
– 160 MHz 2 FCC, 1 EU | |
Note: This varies by regulatory domain. Refer to the product documentation for specific details for each regulatory domain. |
Sản phẩm Cisco C9130AXI-S được phân phối chính hãng bởi
[NETSYSTEM CO.,LTD] – NHÀ PHÂN PHỐI CISCO CATALYST 9100 UY TÍN
[HN] Số 23 Ngõ 477 Phố Kim Mã, P. Ngọc Khánh, Q. Ba Đình,TP. Hà Nội.
[Miền bắc] Hỗ trợ sản phẩm
[Hotline] 0914769119
[Hotline] 091549.5885
[SG] LL1E Đường Tam Đảo, Cư Xá Bắc Hải, Phường 15, Quận 10, TP. Hồ Chí Minh
[Miền nam] Hỗ trợ sản phẩm
[Hotline] 0914025885
[Hotline] 091649.8448
[Tel] +84-24-37714417
[Fax] +84-24-37711222
[Skype] netsystemvn
[Email] contact@netsystem.vn